Reasons for adding lubricant to shredder
Regularly fill the lubricant, because after a period of use of the lubricant, due to the wear of the friction surface and wipe off the metal debris; other dust and dust particles brought in the air; Sand that is not carefully removed on the casting; The paint layer on the waste shredder machine part falls off; Water is produced during cooling to degrade oil; The temperature and other effects of lubricants in circulating lubrication gradually reduce the lubrication properties of the oil, etc., thus affecting the quality of the oil.These impurities are easy to form abrasive paste analogues in lubricants, contaminate the lubricant and greatly accelerate the wear of the friction surface of the machine, so they need to be replaced regularly. Lubricants added to the bearing box need to account for 70% of the total volume and are regularly replaced every two to three months. During the oil change process, you do a good job of cleaning. Always seal it so that dust or other impurities do not enter the working system of the metal shredder, causing damage to the equipment.Metal crushers should also be regularly inspected and maintained. Once the problem is found, the metal shredder should be repaired in a timely manner. At the same time, the wear of consumables should be checked. If the wear is severe, replace it promptly and take the necessary fire protection measures. Metal shredder fragile parts, including hammer head, liner, bearings, etc., easy to break. In use, wear is relatively large and requires frequent maintenance to ensure lubrication between components and very good lubrication between parts of the equipment. Importantly, the service life of the equipment can be effectively extended. When the metal shredder is complete, dust falls on the surface of the machine during the process of crushing the waste. Over time, the machine can corrode, causing a series of adverse effects, so maintenance is carried out after a shutdown.