shredder can quickly break scrap steel pins
The shredder machine can quickly break the scrap iron and steel pins into small particles of scrap iron and steel pins. The shredder machine is the most suitable product for crushing the scrap iron and steel pins. In the shredder machine, scrap steel pins are generally crushed by hammering. Only by hammering the scrap steel pins to a certain degree can they be discharged from the grid holes at the bottom or top of the shredder machine. If it is not cut to a certain degree, then it is necessary to continue hammering until it can be extruded from the bottom and top grid of the shredder machine after cutting to a certain degree. Because the size of the grid openings used by the shredder machine for discharging is in the equipment, the specifications of the materials crushed by the same equipment are the same and the appearance is the same. The scrap iron and steel pins are continuously cut and squeezed in the iron chip shredder machine until they reach the standard and are discharged from the shredder machine. Since the blade of the shredder machine is sheared and alternately cut and squeezed during cutting, the tearing effect is produced by alternately staggered. In this way, the inclusions in the scrap iron and steel pins will easily fall out. Under the continuous hammering of the steel pin, on the one hand, the steel-to-steel collision is constantly carried out, and on the other hand, slippage and scraping occur between the hammer head and the scrap steel. After repeated scraping, the scrap steel can be scrapped Paint on scrap pins and scrap steel. At the same time, a strong impact occurs during the hammering process, and the surface of the scrap steel pin will generate strong heat, which will burn off the paint on the surface of the scrap steel pin.